Selling or refinancing a villa in a Dubai master community triggers a physical inspection before the developer issues a resale No Objection Certificate. Wall removals, pergolas, boundary alterations and extensions that were never approved show up against the approved drawings, and the transaction stops until they are resolved. The time to find this out is not during a sale.
Why this catches owners who did nothing wrong
Two situations account for most of it, and neither involves anyone behaving badly.
The first is buying a home that was already modified. Work done by a previous owner becomes your problem at your sale, not theirs, and nothing in a normal purchase process surfaces it. The drawings you receive are the approved drawings, and unless you compare them against the house you are standing in, a removed wall looks like the original layout.
The second is being told approval was not necessary. A contractor who says a pergola or an internal partition does not need an application is either wrong or is describing a different community's rules. The owner accepts it in good faith and inherits the consequence years later.
What the inspection is looking for
The comparison is between the property as built and the drawings the developer holds. Anything present in one and absent from the other is a discrepancy. In practice the recurring items are internal walls removed to open up a layout, pergolas and shade structures added in the garden, boundary walls raised or altered for privacy, extensions to the built footprint, and rooftop additions.
Scale is not the test. A small permanent structure that needed an application and did not get one is a discrepancy in the same way a room extension is.
What resolution looks like
Two routes, and which one applies depends on whether the work is compliant in substance.
Retroactive approval where the work would have been approved had it been submitted. That means preparing the application that should have existed: drawings of what is actually there, and for structural items a calculation report stamped by a licensed engineering consultant. It is the same engineering the original application would have needed, done later and usually under time pressure.
Reinstatement where the work would not have been approved, because it breaches setbacks, exceeds coverage, or conflicts with the community design code. That means removing it and making good, which is the expensive answer and the reason to find out early.
How to audit your own property
Start with the approved drawings and walk the house against them, room by room, then the garden. Look specifically at internal walls, because a removed wall is the single most common discrepancy and the easiest to miss when you have lived with the result for years. Then look at every permanent structure outside: pergola, shade, outdoor kitchen, boundary treatment, anything with a foundation. Then the roof.
Where something does not match, the useful next question is not whether it was approved but whether it would be. Work that sits comfortably inside the setbacks and the design code is a paperwork exercise. Work that does not is a decision to make with time in hand rather than with a buyer waiting.
If you are planning work now
The whole problem is avoided by applying. In Tilal Al Ghaf that means a community No Objection Certificate through the developer's portal, and a building permit from the relevant authority where the work is structural. Our approvals checklist sets out which category each type of work falls into and what documents it needs, and structural extensions and alterations covers what counts as structural in the first place.